Fosroc lokfix S & P Waterproofing Chemical, Rod Anchoring Grout | Construction Products | Building Products

 Fosroc lokfix S Waterproofing Chemical

Lokfix mix and place grouts are used for high strength corrosion resistant anchoring of bolts and bars from 12-51 mm diameter into concrete, rock, masonry or brickwork where high

speed of installation and early application of load is required.

Permanent installation of reinforcement starter bars, foundation bolts, base plates, balustrading, barriers and safety fences, railway tracks, tie-back anchors, reinforcement

dowelling abutments, ground anchors for towers, cranes, dock sills etc.

Fosroc Lokfix Resin Application Instructions

Surface Preparation before applying Lokfix:

• Optimum performance of Lokfix grouts requires rough sided, dust free holes. Use of rotary percussive drills with air or water flushing is recommended.
• Diamond drilled holes should be under-reamed. Cast holes should preferably be inverse dovetail configuration.
• If parallel-sided holes are cast they should be rough to provide adequate keying.

Fosroc Lokfix Mixing :

1. Lokfix S The pack consists of a can of resin and a plastic bag of hardener. Volume of mixed components: 1.2 litres.
2. Lokfix P The pack consists of a can of resin and a plastic bag of hardener. Volume of mixed components: 1.2 litres.
3. Fosroc Solvent 105 - 4 and 25 litre containers.
4. * A complete pack of resin and catalysed filler should be mixed in one operation. Mixing may be carried out mechanically. When a smooth, even consistency is achieved the grout is ready for   use and should be placed well within the gel time of the grout (See datasheet).
6. Packs have been designed to produce practical and economic volumes of grout. Do not attempt to mix partial pack components.

Lokfix S Application Instructions

• The mixed grout should be poured steadily into the prepared holes. The anchor bar is then pressed into the hole to the required depth. Slight agitation of the bar will assist in achieving a   complete bond. 
• The bar should then be left undisturbed in the required position until the resin is set.
  
  

Lokfix P  Application Instructions

• The grout should be injected to the rear of the hole to avoid air entrapment.
• The thixotropic nature of Lokfix P will prevent significant flow of resin out of the hole.

FOSROC Lokfix Uses:

1. Rapid strength gain
2. Vibration resistant
3. Corrosion resistant
4. Non expansive
5.  Can be placed under water

Health and Safety

•  Lokfix and Fosroc Solvent 105 are flammable.  Do not smoke during use.
•  Confined areas must be well ventilated and no naked flamed allowed. 
•  Contact with the skin should be avoided as certain sensitive skins may be affected by contact with the polyester resin. In such cases if contact with the resin occurs, the skin should be    washed immediately with soap and water - not solvent. 
• Gloves and barrier creams should be used when handling these products. 
• Eye contamination must be immediately washed with plenty of water and medical treatment sought. 

Cleaning:

Any mixing drums, pumps, etc. should be cleaned within the pot life of the grout. Fosroc Solvent 105 is available for this purpose.

Fosroc Lokfix Price

Fosroc Lokfix S/P, 1kg, Packaging Type: Packet Rs 360/ Kilogram

Also this kind of content is similar to this search results

fosroc lokfix chemical,fosroc lokfix chemical price,fosroc lokfix application,

fosroc lokfix data sheet,fosroc lokfix near me,lock fix chemical,fosroc lokfix chemical,

fosroc lokfix chemical price.

Video: